VIDEO GALLERY > F-16 SIDE GRIPS
5-pin connector change
February 1, 2020
In this video you will see how to change the 5 pin connector of F16SGRH. You will need to see this procedure if your connector is damaged and you can not repair it.
F16SGRH Paddle switch change
February 1, 2020
Guide where we show you step by step how to replace the F16SGRH Padle button and its connection cable.
F16SGRH Installation
July 1, 2019
We show the different modes of powering of F16SGRH and how to connect and install it through the Bluetooth LE module to the computer, in this way it will be available for use by any application.
F16SGRH Pairing
July 1, 2019
With the help of RS_HID_DEV tool we will do the pairing of F16SGRH in standalone mode to optimize the axes response. Pay attention to this important video because a well done pairing warranty a good axes system.
F16SGRH Calibration
July 1, 2019
In this video we use a F16SGRH in standalone mode and we will show you how to calibrate the Roll, Pitch and Yaw axes using the RS_HID_DEV tool.
F16SGRH Upgrading
July 1, 2019
Complete procedure using the DCC tool to upgrade the F16SGRH.
F16SGRH BMS example configuration
July 1, 2019
In this video we tech you to configure a slot of F16SGRH for Takeoff and Navigation maneuvers in BMS with the RS_HID_DEV tool. All the slot configurations and keystrokes will be managed through the BLE module.
Takeoff -Nav Test Flight
July 1, 2019
Test flight on BMS to use the configuration done previously for the F16SGRH in the video “F16SGRH BMS example configuration” for takeoff and navigation maneuvers.
F16SGRH Flight Test
July 1, 2019
Test flight with a F/A-18C in DCS using the F16SGR grip without a X/Y base, powering it in standalone mode and using the BLE module. We will use as flight controls its own Pitch, Roll and Yaw axes and two keystrokes for the throttle.