Angle Adjustment not applying to DX axis?
Posted: Fri Aug 19, 2022 11:16 pm
I have adjusted the angle adjustment to 12 deg in HID Tool, and it seams to work fine on the test circle there. A perceived straight pull pulls the DX Measurement red dot down the Pitch line arrow. Switching between Raw and Dx measurements show they are the same (which they should be correct?)
Looking at the standard windows game controller setup I see that there are no axis or buttons displayed for the FSSB R3L MJF SGRH device as pictured on pg. 34 in the manual. So, to me it looks like the angle adjustment settings I set in the HID Tool is not applied to the DX axis.
Anything I'm missing here? Drivers or something?
Using FSSB R3L with a TM Cougar stick, running Windows 11. HID Tool v1.15.1. Firmware: MJF_FW_5_01_0
However, when I try and use the joystick in DCS for example, the adjustment is clearly not working. The same perceived straight pull gives a noticeable amount of left roll (in right handed, so naturally pull to the left then pulling on the stick.). Looking at the standard windows game controller setup I see that there are no axis or buttons displayed for the FSSB R3L MJF SGRH device as pictured on pg. 34 in the manual. So, to me it looks like the angle adjustment settings I set in the HID Tool is not applied to the DX axis.
Anything I'm missing here? Drivers or something?
Using FSSB R3L with a TM Cougar stick, running Windows 11. HID Tool v1.15.1. Firmware: MJF_FW_5_01_0