Page 1 of 1
Axes shows 0 in Realsimulator tool
Posted: Fri Apr 16, 2021 8:21 pm
by BoBik
Hi,
I have just got an issue where axes shows 0 in Realsimulator tool. In for example DCS it works but I have to manually select axis and it does not detect them if I move the stick. Is it broken or what could be wrong? Yesterday it was working fine.
FSSB 3.jpg
FSSB 3-1.jpg
Re: Axes shows 0 in Realsimulator tool
Posted: Sat Apr 17, 2021 10:41 am
by BoBik
In DCC I cannot change firmware because when I disconnect FSSB and select a new one it does not detect FSSB and it does not change anything.
Re: Axes shows 0 in Realsimulator tool
Posted: Sun Apr 18, 2021 10:19 am
by BoBik
I installed RS_HID_DEV 1.09 and firmware MJF_FW3_00_1 and it did the trick and now it works again.
Re: Axes shows 0 in Realsimulator tool
Posted: Tue Apr 20, 2021 9:36 pm
by Dragon
Hi, most probably, was a w10 hid issue, sometimes w10 go a crazy and lost some hids, when this happen, only is necessary remove the device in the devices and printers windows, and connect again the device
In the documentation it’s better described
Please, don’t install or use old firmwares and softwares, use only the last versions, are the most safe and free of bugs